The gaps between control surfaces & body have to be angled, otherwise vertical side becomes side reflector.
The following is example of F-22's slat's gap with wing root -

1786032352223.png

AMCA Static models focus on broad outline & have not shown the feature yet, but the real jet would apparently have it.
[[ depiction in CAD attachment ]]
 

Attachments

Basic CAD model outline of AMCA is ready.
Solid & rendered views in green primer, stealthy tinted canopy.
Cockpit is empty, needs time to model small area with right measurements.
Full surface features remaining, will model 1 by 1.
Started with F-22 model but AMCA got ahead so far.
Fortunately my old laptop didn't crash or hang bcoz Blender's old versions also work sufficiently well for discussion purpose. No GPU needed, just 100-150 MB RAM with Core-2 Duo CPU.
I'll be tweaking this basic CAD as per my comprehension, but i wanted 1st to make a model closest to used in official infographics, so that we can discuss what improvements can be made with minimum modifications, like FOC & MLU.

AMCA Blender, 10 aug'26, object mode, solid view, left side, rear elevated angle,1280x800p.jpg

AMCA Blender, 10 aug'26, object mode, rendered view, left side, elevated angle, 1280x800p.jpg
 
Initial outline of notional cockpit.
1 piece canopy w/o arc.
HMDS instead of HUD.
60 x 24 cms TV, i mean MFD.
From F-22 to F-35, we notice many hard switches, buttons, dials, knobs have been offloaded to MFD & HMDS.

AMCA. blender, 12 aug'26, notional cockpit outline, Edit mode, Solid view, right side rear ele...jpg

AMCA. blender, 12 aug'26, notional cockpit outline, Object mode, Solid view, right side rear e...jpg

AMCA. blender, 12 aug'26, notional cockpit outline, Object mode, Rendered view, right side rea...jpg
 
Different static models & CADs have shown minor differences in fuselage shaping & features.
I wonder which forward & mid fuselage blending contour style is best balance b/w aerodynamics, stealth, needed space.
This will affect components like S-duct, fuel tanks, sensors, etc.
I guess i'll have to make the S-Duct 1st & see if it gets out of any contour boundary.
Then decide the contour, then place the surface sensors & features.
 

Attachments

Top